Sunday, December 17, 2006

Parts for Dream Focusing Device


Parts for Dream Focusing Device
Originally uploaded by bertmac.
Here are the brass parts for the Dream Focusing Device. They need to be really clean so I can put the resist on for etching. Today I sanded them thoroughly. I also made a new top for the receiver. It's the one in the center back. I form the side wall, which is basically a wide bracelet, then I solder that seam. Then I place it on a base which is larger than the oval, and solder the side wall to the base. There are more precise ways to make boxes, but I'm not patient enough. This seems (pun!) to work fine. I need to trim the extra parts of the base away now, and file the edges round. The old top, which is at the lower right, has a small gap in the back seam. It was bothering me, so I figured I had to try to make a better one.

I haven't been in the studio much. Mostly 40 minutes here and there. But it does add up. I can "see" this thing finished now, and am enjoying working on it. We will have a week off later this month, so I'm hoping for some significant progress.

1 comment:

Jade said...

looking marvellous, Judith! Can't wait to see the finished device